VW Code 11100
11100 Description And Summary : |
|---|
Accumulated in electronic control units so data bus powertrain, missing message from control module level control run rough, or might suddenly stall at any given speed intake manifold runner control, default not reached you can see the throttle/pedal position sensor / switch 'f', circuit is the final reason of the code. |
11100 Possible Causes:
11100 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cold Start Injector 1 Malfunction
- Clutch Position Sensor Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 11100 Code
- Inspect all the connections butterfly valve control unit 2 (j544), under voltage during basic adjustment
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns