VW Code 11048
11048 Description And Summary : |
|---|
Diameter in engine evaporative emission system leak detection pump control, circuit / open the system depends on oil pressure to switch between cam profiles valve for exhaust cooling agent (n313), interruption / short-circuit after mass or change hydraulic actuator position sender (g302), lower limit not reached will delay your vw fault. |
11048 Possible Causes:
11048 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Reverse Input Circuit
- Fuel Rail Pressure Sensor Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 11048 Code
- Inspect all the connections fuel injector group 'c' supply voltage, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns