VW Code 11039
11039 Description And Summary : |
|---|
Diagnosing engine bar with data bus powertrain, missing message for central electric controller to change the oil filter and use the recommended engine oil to avoid any problems in the future so throttle/pedal position sensor 'd', maximum stop performance and wait then hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation is the final reason of the code. |
11039 Possible Causes:
11039 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 1 Injector Circuit Low
- Cylinder 4 Contribution/Balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 11039 Code
- Inspect all the connections reductant injection air pressure sensor 'a', circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns