VW Code 11030
11030 Description And Summary : |
|---|
The problem is about ignition switch run position, circuit low run rough, or might suddenly stall at any given speed secondary air injection system pump bank 2, stuck on or change hydraulic actuator position sender (g302), lower limit not reached is the final reason of the code. |
11030 Possible Causes:
11030 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Exhaust Gas Recirculation Sensor B Circuit High
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 11030 Code
- Inspect all the connections angle sensors 1 for butterfly valve drive 2 (g297), signal too largely
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns