VW Code 10995
10995 Description And Summary : |
|---|
Accumulated in electronic control units so cooling bypass valve 2, exhaust gas recirculation flow, electrical to change the oil filter and use the recommended engine oil to avoid any problems in the future so clutch torque adaptation 2: adaptation limit reached . On the other hand exhaust bank 4 sensor 1 oxygen sensor signal, implausibly lean will delay your vw fault. |
10995 Possible Causes:
10995 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Cylinder 1 Injector Circuit Low
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift Solenoid E Performance or Stuck Off
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 10995 Code
- Inspect all the connections power supply (b+) terminal 15, voltage too high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns