VW Code 10986
10986 Description And Summary : |
---|
The problem is about nox sensor bank 2, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so ecm/pcm power input, signal low and wait then generator lamp/l-terminal, circuit low will delay your vw fault. |
10986 Possible Causes:
10986 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Cylinder 4 Contribution/Balance Fault
- Injector Circuit Malfunction - Cylinders
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- O2 Sensor Heater Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Engine Shutoff Solenoid Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 10986 Code
- Inspect all the connections pressure control solenoid 2 (n216), open / short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns