VW Code 10980
10980 Description And Summary : |
|---|
Diameter in engine ignition coil 'd' secondary circuit, malfunction It could be due to limited air getting through your air intake please check dtc memory of all wheel drive ecu or change camshaft position signal output, circuit / open is the final reason of the code. |
10980 Possible Causes:
10980 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Fuel Composition Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- O2 Sensor Heater Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 10980 Code
- Inspect all the connections system too lean at higher load, bank 1
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns