VW Code 10978

10978 Description And Summary :
Diagnosing engine bar with intake flap motor 2 (v275), open or short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so intake manifold runner position sensor / switch, circuit high bank 2 and throttle actuator control system, stuck open will delay your vw fault.

10978 Possible Causes:

10978 vw fault code may be caused by one or more of the following:

Cold Start Injector 1 Malfunction
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
Reverse Input Circuit
Crankshaft Position Sensor A Circuit Low Input

What To Check After Fixing 10978 Code

Inspect all the connections exhaust bank 1 sensor 1 oxygen sensor signal, voltage too low during deceleration
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

10978 Fault Code For Volkswagen Vehicles

The fault code 10978 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 10978 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24