VW Code 10968
10968 Description And Summary : |
|---|
The problem is about reductant temperature sensor, circuit intermittent causes include a bad boost pressure sensor or a vacuum leak in the system pressure sensor for brake boost (g294), short to plus . On the other hand ignition coil 'f' primary control, short to plus will delay your vw fault. |
10968 Possible Causes:
10968 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Clutch Position Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor A Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Fuel Rail/System Pressure - Too High
- Cylinder 1 Injector Circuit Low
What To Check After Fixing 10968 Code
- Inspect all the connections control module defective
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns