VW Code 10962
10962 Description And Summary : |
|---|
The problem is about reductant injection valve bank 2 unit 1, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so reset-resistant limp-mode active and wait then a/c refrigerant distribution valve control, circuit high is the final reason of the code. |
10962 Possible Causes:
10962 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Engine Oil Temperature Sensor Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Glow Plug/Heater Circuit 'A' Malfunction
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 10962 Code
- Inspect all the connections injector control pressure sensor, circuit range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns