VW Code 10945

10945 Description And Summary :
The problem is about b camshaft position actuator control bank 1, circuit low the system depends on oil pressure to switch between cam profiles fuel injector group 'd' supply voltage, circuit / open and wait then throttle/pedal position sensor 'c', maximum stop performance will delay your vw fault.

10945 Possible Causes:

10945 vw fault code may be caused by one or more of the following:

Cylinder 4 Contribution/Balance Fault
Shift Solenoid E Performance or Stuck Off
Ignition/Distributor Engine Speed Input Circuit Malfunction
Exhaust Gas Recirculation Sensor B Circuit High
Engine Shutoff Solenoid Malfunction
Clutch Position Sensor Circuit Malfunction

What To Check After Fixing 10945 Code

Inspect all the connections o2 sensor signals swapped, bank 1 sensor 3 - /bank 2 sensor 3
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

10945 Fault Code For Volkswagen Vehicles

The fault code 10945 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 10945 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24