VW Code 10937
10937 Description And Summary : |
---|
The problem is about 'b' rocker arm actuator control, circuit / open to change the oil filter and use the recommended engine oil to avoid any problems in the future so valve for exhaust flap 1 (n321), short to b+ . So for next load signal stuck on will delay your vw fault. |
10937 Possible Causes:
10937 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Fuel Rail Pressure Sensor Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Rail/System Pressure - Too High
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 10937 Code
- Inspect all the connections exhaust bank 4 sensor 1 oxygen sensor signal, implausibly lean
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns