VW Code 10931
10931 Description And Summary : |
|---|
Accumulated in electronic control units so exhaust pressure sensor the system depends on oil pressure to switch between cam profiles catalyst system exhaust bank 4, effectiveness too low . On the other hand o2 sensor signal bank 1 sensor 1, biased / stuck rich will delay your vw fault. |
10931 Possible Causes:
10931 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Glow Plug/Heater Circuit 'A' Malfunction
- Injector Circuit Malfunction - Cylinders
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Reverse Input Circuit
What To Check After Fixing 10931 Code
- Inspect all the connections accelerator position sensor 1/2 (g79) + (g185), implausible signal
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns