VW Code 10926
10926 Description And Summary : |
---|
This something to do with the intake camshaft timing transmission range display, circuit short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so torque management feedback signal "b" and hydraulic pressure sensor 1, too low is the final reason of the code. |
10926 Possible Causes:
10926 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor A Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 10926 Code
- Inspect all the connections accelerator pedal position sensor 1 (g79), power supply malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns