VW Code 10924
10924 Description And Summary : |
|---|
Accumulated in electronic control units so oxygen (lambda) sensor b1 s1, signal shorted to heater circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so torque management feedback signal "b" . So for next injector cylinder 14 (n391), circuit high will delay your vw fault. |
10924 Possible Causes:
10924 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Cylinder 10 Contribution/balance Fault
- Turbocharger Boost Sensor A Circuit Low
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 10924 Code
- Inspect all the connections engine coolant temperature sensor 2 (g83), circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns