VW Code 10913

10913 Description And Summary :
This code were stamped on VW Engine case angle sensors 1 for butterfly valve drive 2 (g297), signal too small to change the oil filter and use the recommended engine oil to avoid any problems in the future so glow plug/heater relay 2 circuit, short to b+ or change manifold absolute pressure / mass air flow - throttle position correlation at higher load will delay your vw fault.

10913 Possible Causes:

10913 vw fault code may be caused by one or more of the following:

Engine Oil Temperature Sensor Malfunction
Injector Circuit Malfunction - Cylinders
Ignition/Distributor Engine Speed Input Circuit Malfunction
Fuel Composition Sensor Circuit Malfunction
Fuel Temperature Sensor B Circuit Range/Performance
Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)

What To Check After Fixing 10913 Code

Inspect all the connections transmission coolant circuit relay, short to b+
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

10913 Fault Code For Volkswagen Vehicles

The fault code 10913 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 10913 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24