VW Code 10906
10906 Description And Summary : |
|---|
The problem is about exhaust pressure regulator vent solenoid, control circuit / open to change the oil filter and use the recommended engine oil to avoid any problems in the future so 'b' rocker arm actuator control, circuit low . So for next throttle/pedal position sensor / switch 'd', circuit intermittent is the final reason of the code. |
10906 Possible Causes:
10906 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 1 Injector Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Cold Start Injector 1 Malfunction
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 10906 Code
- Inspect all the connections exhaust bank 3, probe 2 heating circuit interruption
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns