VW Code 10896
10896 Description And Summary : |
|---|
Staring in engine drive by wire-mil (k132), circuit short to ground the system depends on oil pressure to switch between cam profiles valve for exhaust flap 1 (n321), short to b+ and wait then torque management feedback signal "a", high is the final reason of the code. |
10896 Possible Causes:
10896 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Clutch Position Sensor Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 10896 Code
- Inspect all the connections exhaust bank 1 mixture adaptation range 3, rich limit exceeded
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns