VW Code 10875
10875 Description And Summary : |
---|
This code were stamped on VW Engine case cylinder 1 above knock threshold to change the oil filter and use the recommended engine oil to avoid any problems in the future so relay for supply voltage terminal 30 (j317), implausible signal or change secondary air injection pump-d-relay (j705), circuit open circuit will delay your vw fault. |
10875 Possible Causes:
10875 vw fault code may be caused by one or more of the following:
- Fuel Composition Sensor Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Cold Start Injector 1 Malfunction
- Clutch Position Sensor Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 10875 Code
- Inspect all the connections relays for pump, fuel cooling (j445), short-circuit after pluses
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns