VW Code 10864
10864 Description And Summary : |
|---|
This code were stamped on VW Engine case starter activation, return message terminal 50, implausible signal to change the oil filter and use the recommended engine oil to avoid any problems in the future so turbocharger boost control position sensor 'b', circuit low and wait then pressure control solenoid 6 (n371) open / short to ground will delay your vw fault. |
10864 Possible Causes:
10864 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Cylinder 4 Contribution/Balance Fault
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Rail Pressure Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 10864 Code
- Inspect all the connections a camshaft position actuator control bank 1, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns