VW Code 10860
10860 Description And Summary : |
|---|
This code were stamped on VW Engine case b camshaft position actuator control bank 2, circuit low the system depends on oil pressure to switch between cam profiles shift lock, short to b+ . On the other hand torque management feedback signal "a", low will delay your vw fault. |
10860 Possible Causes:
10860 vw fault code may be caused by one or more of the following:
- Fuel Rail Pressure Sensor Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Cold Start Injector 1 Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 10860 Code
- Inspect all the connections rough road / engine torque signal from abs; electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns