VW Code 10841
10841 Description And Summary : |
|---|
This code were stamped on VW Engine case injector control pressure sensor, circuit intermittent to change the oil filter and use the recommended engine oil to avoid any problems in the future so control module 1 for cooling fan, faulty . On the other hand throttle/pedal position sensor 'e', maximum stop performance will delay your vw fault. |
10841 Possible Causes:
10841 vw fault code may be caused by one or more of the following:
- Ambient Air Temperature Sensor Circuit Low
- Clutch Position Sensor Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Cold Start Injector 1 Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Fuel Composition Sensor Circuit Malfunction
What To Check After Fixing 10841 Code
- Inspect all the connections coolant pump control, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns