VW Code 108
108 Description And Summary : |
|---|
The problem is about potentiometer 2 for egr (g466), incorrect basic setting to change the oil filter and use the recommended engine oil to avoid any problems in the future so injector control pressure, too low - engine cranking and wait then ignition switch run/start position, circuit high will delay your vw fault. |
108 Possible Causes:
108 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Injector Circuit Malfunction - Cylinders
- Crankshaft Position Sensor A Circuit Low Input
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 108 Code
- Inspect all the connections throttle/pedal position sensor 'c', minimum stop performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns