VW Code 10787
10787 Description And Summary : |
---|
This code were stamped on VW Engine case mil call-up circuit / transmission control module, short to ground the system depends on oil pressure to switch between cam profiles fuel rail sensor (g401), short to b+ . On the other hand starter interlock, circuit open is the final reason of the code. |
10787 Possible Causes:
10787 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Cold Start Injector 1 Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 10787 Code
- Inspect all the connections intake manifold runner control, default not reached
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns