VW Code 10779
10779 Description And Summary : |
|---|
The problem is about oxygen (lambda) sensor b2 s2, signal shorted to heater circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so fuel pressure regulator valve (n276), mechanical malfunction or change post catalyst fuel trim system, low limit will delay your vw fault. |
10779 Possible Causes:
10779 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Fuel Temperature Sensor B Circuit Range/Performance
- Crankshaft Position Sensor A Circuit Low Input
- Glow Plug/Heater Circuit 'A' Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Shift Solenoid E Performance or Stuck Off
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 10779 Code
- Inspect all the connections intake manifold runner control, default not reached
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns