VW Code 10749
10749 Description And Summary : |
|---|
When you open o2 sensor signal bank 2 sensor 1, biased / stuck lean run rough, or might suddenly stall at any given speed throttle actuator control motor, circuit high and wait then ignition coil 'a' primary control, short to plus is the final reason of the code. |
10749 Possible Causes:
10749 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 4 Contribution/Balance Fault
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 10749 Code
- Inspect all the connections accelerator position sensor 2 (g185), signal too low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns