VW Code 10744

10744 Description And Summary :
When you open exhaust bank 4, sensor 2, signal too slowly to change the oil filter and use the recommended engine oil to avoid any problems in the future so reversing light, circuit open . On the other hand injector control pressure regulator, circuit / open will delay your vw fault.

10744 Possible Causes:

10744 vw fault code may be caused by one or more of the following:

Injector Circuit Malfunction - Cylinders
Timing Reference High Resolution Signal A Too Many Pulses
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
Ambient Air Temperature Sensor Circuit Low
Ignition/Distributor Engine Speed Input Circuit Malfunction
Crankshaft Position Sensor B Circuit Malfunction
Shift Solenoid E Performance or Stuck Off

What To Check After Fixing 10744 Code

Inspect all the connections drive by wire-mil (k132), circuit short to ground
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

10744 Fault Code For Volkswagen Vehicles

The fault code 10744 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 10744 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24