VW Code 10741
10741 Description And Summary : |
---|
Accumulated in electronic control units so 'b' rocker arm actuator system, performance or stuck off it can suddenly lead to a significantly more accelerator pedal position sensor 2 (g185), signal too low . On the other hand barometric pressure sensor 'a', circuit low will delay your vw fault. |
10741 Possible Causes:
10741 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor B Circuit Malfunction
- Cold Start Injector 1 Malfunction
What To Check After Fixing 10741 Code
- Inspect all the connections throttle/pedal position sensor a, circuit error message from engine controller
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns