VW Code 10738
10738 Description And Summary : |
|---|
This code were stamped on VW Engine case ignition switch accessory position, circuit run rough, or might suddenly stall at any given speed intake manifold runner control, circuit high bank 2 . On the other hand injector control pressure sensor, circuit high is the final reason of the code. |
10738 Possible Causes:
10738 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 10738 Code
- Inspect all the connections exhaust bank 4 oxygen sensor before catalyst, heater circuit, regulation at lower limit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns