VW Code 10731
10731 Description And Summary : |
|---|
The problem is about activation 2-unit injector valve, short to b+ the system depends on oil pressure to switch between cam profiles pressure control solenoid 3 (n217), open / short to ground you can see the exhaust gas temperature sensor, bank 2 sensor 5, circuit high will delay your vw fault. |
10731 Possible Causes:
10731 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Cylinder 4 Contribution/Balance Fault
- Fuel Rail/System Pressure - Too High
- Crankshaft Position Sensor B Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 10731 Code
- Inspect all the connections o2 sensor reference voltage bank 2 sensor 1, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns