VW Code 10708
10708 Description And Summary : |
|---|
Staring in engine valve for pump - jet: cylinder 9 (n305), circuit low input to change the oil filter and use the recommended engine oil to avoid any problems in the future so ecm/pcm power input, signal high . On the other hand synchronisation line is the final reason of the code. |
10708 Possible Causes:
10708 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- O2 Sensor Heater Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift Solenoid E Performance or Stuck Off
- Fuel Rail/System Pressure - Too High
- Injector Circuit Malfunction - Cylinders
- Crankshaft Position Sensor B Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 10708 Code
- Inspect all the connections intake manifold runner position sensor / switch, circuit intermittent bank 2
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns