VW Code 10707
10707 Description And Summary : |
|---|
Staring in engine valve for pump - jet: cylinder 7 (n303), regulation range exceeded to change the oil filter and use the recommended engine oil to avoid any problems in the future so o2 sensor signal bank 1 sensor 3, biased / stuck rich and control module defective will delay your vw fault. |
10707 Possible Causes:
10707 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Clutch Position Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 10707 Code
- Inspect all the connections data-bus powertrain, implausible message from brake controller
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns