VW Code 10702
10702 Description And Summary : |
---|
This code were stamped on VW Engine case change-over valve for intake manifold flap 2, performance or stuck off run rough, or might suddenly stall at any given speed oxygen (lambda) sensor b1 s1, pump current, short to b+ and wait then throttle position (tp) sensor 1-2, correlation will delay your vw fault. |
10702 Possible Causes:
10702 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- Fuel Rail/System Pressure - Too High
- Clutch Position Sensor Circuit Malfunction
- Reverse Input Circuit
- Crankshaft Position Sensor A Circuit Low Input
- Cold Start Injector 1 Malfunction
What To Check After Fixing 10702 Code
- Inspect all the connections torque management feedback signal "b", high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns