VW Code 10698
10698 Description And Summary : |
|---|
Accumulated in electronic control units so exhaust gas temperature sensor bank 1 sensor 2, circuit high run rough, or might suddenly stall at any given speed linear oxygen sensor exhaust bank 3 / common ground wire, open circuit . So for next mass-airflow sensor 4 (g457), signal to low will delay your vw fault. |
10698 Possible Causes:
10698 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Glow Plug/Heater Circuit 'A' Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Timing Reference High Resolution Signal A Too Many Pulses
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Rail Pressure Sensor Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 10698 Code
- Inspect all the connections data bus powertrain, no message from transmission controller (tcu)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns