VW Code 10692

10692 Description And Summary :
This code were stamped on VW Engine case ignition coil 'g' primary control, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so throttle/pedal position sensor / switch 'f', circuit low and starter does not run, mechanically blocked or mechanical malfunction will delay your vw fault.

10692 Possible Causes:

10692 vw fault code may be caused by one or more of the following:

Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
Cold Start Injector 1 Malfunction
Injector Circuit Malfunction - Cylinders
Manifold Absolute Pressure/Barometric Pressure Circuit High Input
Timing Reference High Resolution Signal A Too Many Pulses
Fuel Temperature Sensor B Circuit Range/Performance

What To Check After Fixing 10692 Code

Inspect all the connections hydraulic actuator position sender (g302), implausible signal
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

10692 Fault Code For Volkswagen Vehicles

The fault code 10692 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 10692 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24