VW Code 10677
10677 Description And Summary : |
|---|
This code were stamped on VW Engine case hydraulic actuator position sender (g302), upper limit exceeded run rough, or might suddenly stall at any given speed manifold absolute pressure / mass air flow - throttle position correlation at higher load you can see the throttle actuator control system, forced idle will delay your vw fault. |
10677 Possible Causes:
10677 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Engine Shutoff Solenoid Malfunction
- Shift Solenoid E Performance or Stuck Off
- O2 Sensor Heater Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 10677 Code
- Inspect all the connections cylinder 4 above knock threshold
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns