VW Code 10676
10676 Description And Summary : |
|---|
This code were stamped on VW Engine case actuator supply voltage 'c', circuit high causes include a bad boost pressure sensor or a vacuum leak in the system secondary air injection system control 'b', circuit high and wait then angle sensors 1 for butterfly valve drive 2 (g297), signal too small will delay your vw fault. |
10676 Possible Causes:
10676 vw fault code may be caused by one or more of the following:
- Injector Circuit Malfunction - Cylinders
- Fuel Temperature Sensor B Circuit Range/Performance
- Cylinder 4 Contribution/Balance Fault
- Crankshaft Position Sensor B Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Fuel Composition Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 10676 Code
- Inspect all the connections exhaust bank 4 sensor 1 heater circuit, internal resistance too large
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns