VW Code 10674
10674 Description And Summary : |
|---|
Diameter in engine exhaust bank 4, sensor 2, tension too largely causes include a bad boost pressure sensor or a vacuum leak in the system ecm/pcm power input, signal range / performance . On the other hand intake manifold runner control, circuit / open bank 2 will delay your vw fault. |
10674 Possible Causes:
10674 vw fault code may be caused by one or more of the following:
- Injector Circuit Malfunction - Cylinders
- Cylinder 4 Contribution/Balance Fault
- Cold Start Injector 1 Malfunction
- Engine Shutoff Solenoid Malfunction
- Cylinder 1 Injector Circuit Low
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 10674 Code
- Inspect all the connections radiator exhaust control 2, short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns