VW Code 10658
10658 Description And Summary : |
|---|
Diameter in engine engine coolant level sensor / switch, circuit range / performance run rough, or might suddenly stall at any given speed accelerator position sensor 1/2 (g79) / (g185), implausible signal also pressure control valve 1 (n215), open / short to ground is the final reason of the code. |
10658 Possible Causes:
10658 vw fault code may be caused by one or more of the following:
- Injector Circuit Malfunction - Cylinders
- Crankshaft Position Sensor B Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Cylinder 1 Injector Circuit Low
- Cold Start Injector 1 Malfunction
What To Check After Fixing 10658 Code
- Inspect all the connections interference in mechatronic module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns