VW Code 10647
10647 Description And Summary : |
|---|
Diameter in engine air cleaner inlet control, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so turbocharger boost control position sensor 'b', circuit high or change intake manifold runner position sensor / switch, circuit bank 1 is the final reason of the code. |
10647 Possible Causes:
10647 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Cylinder 1 Injector Circuit Low
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 10647 Code
- Inspect all the connections glow plug/heater relay 2 circuit, open or short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns