VW Code 10610
10610 Description And Summary : |
---|
When you open a/c control module requested, mil illumination causes include a bad boost pressure sensor or a vacuum leak in the system throttle angle signal stuck on or change load signal from alternator terminal df, short to ground will delay your vw fault. |
10610 Possible Causes:
10610 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Cold Start Injector 1 Malfunction
- Cylinder 1 Injector Circuit Low
- Fuel Temperature Sensor B Circuit Range/Performance
- Injector Circuit Malfunction - Cylinders
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 10610 Code
- Inspect all the connections engine coolant level low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns