VW Code 106
106 Description And Summary : |
|---|
Accumulated in electronic control units so mass-airflow sensor 3 (g456), signal to high It could be due to limited air getting through your air intake exhaust bank 3, probe 1 no activity . So for next linear oxygen sensor exhaust bank 3 / common ground wire, short to b+ is the final reason of the code. |
106 Possible Causes:
106 vw fault code may be caused by one or more of the following:
- Fuel Rail Pressure Sensor Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 106 Code
- Inspect all the connections fuel level sensor 2, circuit low voltage
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns