VW Code 10578
10578 Description And Summary : |
|---|
The instrument cluster alerts the driver to the fault injector control pressure regulator, circuit / open run rough, or might suddenly stall at any given speed vehicle speed sensor 'b', range / performance . So for next pressure control solenoid 3 (n217), short to b+ is the final reason of the code. |
10578 Possible Causes:
10578 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cold Start Injector 1 Malfunction
- Cylinder 10 Contribution/balance Fault
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 10578 Code
- Inspect all the connections manifold absolute pressure / mass air flow - throttle position correlation at higher load
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns