VW Code 10573
10573 Description And Summary : |
|---|
When you open o2 sensor pumping current trim bank 2 sensor 1, circuit / open the system depends on oil pressure to switch between cam profiles evaporative emission system leak detection pump sense, circut high you can see the bank 2 sensor 1, internal resistance implausible will delay your vw fault. |
10573 Possible Causes:
10573 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- O2 Sensor Heater Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 10573 Code
- Inspect all the connections throttle position (tp) sensor (g79), error message from ecm
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns