VW Code 10528
10528 Description And Summary : |
|---|
Accumulated in electronic control units so supply voltage for fuel injector group a, short to b+ retarded timing position, the engine might refuse to start injector control pressure, too low - engine cranking and throttle/pedal position sensor 'a', minimum stop performance will delay your vw fault. |
10528 Possible Causes:
10528 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- O2 Sensor Heater Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Engine Oil Temperature Sensor Malfunction
- Reverse Input Circuit
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 10528 Code
- Inspect all the connections linear oxygen sensor exhaust bank 1, compensation wire pump current, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns