VW Code 10525
10525 Description And Summary : |
|---|
This something to do with the intake camshaft timing starter does not run, mechanically blocked or mechanical malfunction It could be due to limited air getting through your air intake mass-airflow sensor 3 (g456), signal to high . On the other hand reductant injection valve bank 2 unit 2, circuit low will delay your vw fault. |
10525 Possible Causes:
10525 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Fuel Rail/System Pressure - Too High
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 10525 Code
- Inspect all the connections intake manifold tuning (imt) valve position sensor / switch bank 1, circuit intermittent
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns