VW Code 10506
10506 Description And Summary : |
|---|
The problem is about exhaust gas temperature control bank 3, range / performance to change the oil filter and use the recommended engine oil to avoid any problems in the future so pressure control solenoid 5 (n233), electrical malfunction . So for next injector control pressure regulator, circuit / open will delay your vw fault. |
10506 Possible Causes:
10506 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 10506 Code
- Inspect all the connections bank 2, cam shaft position sensor, discharge opening (g301), short-circuit to mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns