VW Code 105
105 Description And Summary : |
|---|
Diameter in engine intake manifold runner control, circuit / open bank 2 the system depends on oil pressure to switch between cam profiles secondary air injection system air flow/pressure sensor bank 2, circuit and wait then hydraulic pressure sensor 2, range / performance is the final reason of the code. |
105 Possible Causes:
105 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- O2 Sensor Heater Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Cold Start Injector 1 Malfunction
- Fuel Rail/System Pressure - Too High
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 105 Code
- Inspect all the connections turbo/super charger, under-boost condition
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns