VW Code 10460
10460 Description And Summary : |
|---|
Accumulated in electronic control units so throttle/pedal position sensor / switch 'e', circuit retarded timing position, the engine might refuse to start bank 2, exhaust cam wave position sensor (g301) / crankshaft position sensor (g28), wrong allocation . So for next hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation is the final reason of the code. |
10460 Possible Causes:
10460 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Fuel Rail Pressure Sensor Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Engine Shutoff Solenoid Malfunction
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 10460 Code
- Inspect all the connections sensor 3 for intake air temperature (g520), signal low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns