VW Code 10451
10451 Description And Summary : |
|---|
Accumulated in electronic control units so 'b' rocker arm actuator control, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust bank 4, sensor 2, signal too slowly and wait then event data recorder request, circuit high is the final reason of the code. |
10451 Possible Causes:
10451 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Reverse Input Circuit
- Glow Plug/Heater Circuit 'A' Malfunction
- Engine Shutoff Solenoid Malfunction
- Engine Oil Temperature Sensor Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 10451 Code
- Inspect all the connections glow plug / heater relay, circuit short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns